---

---

D6 amplifier

The d&b D6 amplifier is a dual channel amplifier incorporating digital signal processors (DSP) to provide loudspeaker specific configurations and functions. It is designed for use with d&b loudspeakers except the 2-Way Active mode and the B2-SUB configurations, has both digital and analog signal inputs as well as link outputs, remote control and monitoring capabilities and sophisticated protection circuits. It utilizes a switch mode power supply with PFC suitable for mains supply voltages 100 V / 115 V / 200 V / 230 V, 50 – 60 Hz and has a temperature and signal controlled fan to cool the internal assemblies. It is specifically designed to deliver medium power into low impedance loads between 4 and 16 ohms. A user definable 4-band parametric equalizer and signal delay capability of up to 340 ms are incorporated and can be applied independently to each channel. A signal generator offering pink noise or sine wave program is also incorporated. The D6 uses its Load monitoring and System check functions to ascertain the status of the loudspeaker impedance. d&b System check verifies that the system performs within a predefined condition, whilst d&b Load monitoring enables an automatic and continuous impedance monitoring. Both can determine the status of an LF or HF driver in systems with multiple elements, even if these are crossed over passively. All of these functions and parameters can be easily accessed and controlled via the LCD in conjunction with the digital rotary encoder or through the d&b Remote network.

---

Data

D6 data (linear setting with subsonic filter)
Rated output power (THD+N < 0.1%)	2 x 350 W into 8 Ω, both channels are driven 2 x 600 W into 4 Ω, both channels are driven
S/N ratio (unweighted, RMS)	> 110 dBr
D6 Connectors
INPUT/LINK ANALOG A/B	3 pin XLR female/male
INPUT/LINK DIGITAL AES/EBU	3 pin XLR female/male
Sampling rate	48 kHz / 96 kHz
OUT CHANNEL A/B	NL4
REMOTE	2 x RJ 45 parallel
SERVICE	USB Type B
D6 Digital Signal Processing
Sampling rate	96 kHz / 27 Bit ADC / 24 Bit DAC
Basic delay / latency analog input	0.3 ms
D6 Power supply
Autosensing switch mode power supply for	100/115/200/230V, 50 - 60 Hz
Mains connector	PowerCon®
D6 Remote network
Remote network	CAN-Bus
D6 Dimensions, weight
Height x width x depth	2 RU x 19" x 353 mm / 13.9"
Weight	8 kg / 17.6 lb

---

PowerCon® is a registered trademark of the Neutrik AG, Liechtenstein

---

We reserve the right to make any necessary changes to the products and the published specification. As part of our ongoing product development program we try, where possible, to maintain the highest degree of product compatibility.

---

---

Documentation

---

Order form for printed documentation from d&b.

---

---

• Top.
• Feedback.