T10 Architectural specifications

The 2-way dipolar, passive loudspeaker shall consist of two 6.5" low frequency driver with a neodymium magnet assembly and one 1.4" exit neodymium compression driver mounted to a dedicated wave shaping device and a passive crossover network.
From the outside, the wave shaping device shall be mechanically rotatable through 90° to allow either line or point soure configurations in connection with an acoustic lense which shall be integrated in the front grill.
The loudspeaker shall only be operated by a dedicated, compatible controller amplifier.

The cabinet enclosure shall be made from polyurethane integral hard foam with an impact and weather protected PCP (Polyurea Cabinet Protection) finish.
The drivers shall be protected by a rigid metal grill backed by an acoustically transparent foam.
The cabinet shall incorporate a three point rigging system for the assembly of vertical line source arrays of up to 24 cabinets in connection with a dedicated flying frame.

The connection panel on the back shall be recessed and fitted with speakon NLT4 F/M sockets. NL4 or EP5 connectors shall be available upon request.

In Line source configuration the loudspeaker shall have a nominal horizontal dispersion angle of 105°. The vertical dispersion angle of the assembled array shall be determined by the geometry of the splay angles between the cabinets, which shall be adjustable in a range of 0° to 15° in 1° increments.
In Point source configuration the loudspeaker shall have a nominal dispersion angle of 90° x 35° (hor x ver).

The power handling capacity shall be 200 W RMS and 800 W peak (10 ms). The frequency response (–5 dB) measured on axis shall be 68 Hz to 18 kHz with a maximum sound pressure of at least 132 dB (line source mode) resp. 130 dB (point source mode).

The dimensions (W x H x D) shall not exceed 470 x 197 x 300 mm (18.5" 7.75x " x 11.8") and shall weigh no more than 11 kg (24 lb).

The loudspeaker shall be the T10 by: d&b audiotechnik GmbH & Co. KG.